16
Part. 14000001
Rev. 04//2021
®/™ ©2021 Unity Laundry Systems. All rights reserved.
INSTALLATION
3.2 FOUNDATION REQUIREMENTS
The machine must be placed on a solid floor which is level in both directions, and of a sufficient strength to be able to support
the static and dynamic loads of the machine, existing machinery, and the means of transport.
WARNING
To reduce the risk of fire, serious injury, property damage and/or
death, install the machine on a level floor of sufficient strength.
3.3 WATER CONNECTION
To connect water service to a machine with hoses, use the following procedure:
1. Before installing hoses, flush the building’s water system at the machine connection valves for at least two [2] minutes.
2. Check filters and seals in the machine’s inlet adapter hoses for proper fit and cleanliness before connecting.
3. Cold water must be supplied to the Soap Dispenser (DETERGENT FLUSH) Inlet for proper operation.
4. All water supply connections to the machine must have manual shut-off valves to facilitate installation and service.
5. Water inlet pressure must be between 13 and 43.5 PSI (1-3 Bar) to ensure proper operation of the machine.
6. Thread the 3 supplied brass fitting adapters and inlet strainer washers on the valve connections. Finger tight then turn ¼
turn with pliers. Do not cross thread or overtighten connection or leakage will occur.
7. Thread hose couplings on the water supply hose onto the (brass) valve connection. Finger tight then turn ¼ turn with pliers.
Do not cross thread or overtighten connection or leakage will occur.
8. Hang hoses in a large loop; do not allow them to kink or to be stretched taut.
9. Check connections for water leaks before putting machine into operation.
