Vision™ OPLC™, V1040-T20B
2
Removable
Memory Storage
Micro-SD card: store datalogs, Alarms, Trends, Data Tables; export to Excel;
backup Ladder, HMI & OS and use this data to ‘clone’ PLCs.
For more data, refer to the
SD
topics in the VisiLogic Help system.
Data Tables
Data tables enable you to set recipe parameters and create datalogs.
Additional product documentation is in the Technical Library, located at
Technical support is available at the site, and from [email protected].
Standard Kit Contents
Vision controller
USB programming cable (Type A to Mini
3 pin power supply connector
Mounting brackets (x8)
5 pin CANbus connector
Rubber seal
CANbus network termination resistor
Unitronics’ Setup CD
Battery (not installed)
Danger Symbols
When any of the following symbols appear, read the associated information carefully.
Symbol Meaning Description
Danger
The identified danger causes physical and property damage.
Warning
The identified danger could cause physical and property damage.
Caution
Caution Use
caution.
Before using this product, the user must read and understand this document.
All examples and diagrams are intended to aid understanding, and do not guarantee operation.
Unitronics accepts no responsibility for actual use of this product based on these examples.
Please dispose of this product according to local and national standards and regulations.
Only qualified service personnel should open this device or carry out repairs.
Failure to comply with appropriate safety guidelines can cause severe injury or property damage.
Do not attempt to use this device with parameters that exceed permissible levels.
To avoid damaging the system, do not connect/disconnect the device when power is on.
Environmental Considerations
Do not install in areas with: excessive or conductive dust, corrosive or flammable gas,
moisture or rain, excessive heat, regular impact shocks or excessive vibration, in accordance
with the standards given in the product’s technical specification sheet.
Ventilation: 10mm space required between controller’s top/bottom edges & enclosure walls.
Do not place in water or let water leak onto the unit.
Do not allow debris to fall inside the unit during installation.
Install at maximum distance from high-voltage cables and power equipment.
Installation Guide
Unitronics
Tables; export to Excel;
PLCs.
Help system.
create datalogs.
.
ype A to Mini-B)
carefully.
property damage.
and property damage.
ent.
t guarantee operation.
n these examples.
and regulations.
airs.
njury or property damage.
issible levels.
ce when power is on.
or flammable gas,
e vibration, in accordance
et.
dges & enclosure walls.
uipment.
