VERSAMET 4 INVERTED METALLURGICAL MICROSCOPE
UNITRON
73 Mall Drive, Commack, NY 11725 • 631-543-2000 • www.unitronusa.com
10
ASSEMBLY
(continued)
Installing the Color Filter Slider
(Fig. 8)
The Versamet 4 is equipped with three filters (green,
yellow and clear daylight blue), and a three position
filter slider
①
that is inserted into the filter slot
②.
The middle position on the filter slider is empty for
brightfield observation, (or simply remove the filter
slider). The other two positions are empty so that you
may insert the any of the other filters into these
positions.
To insert a filter into the filter slider, position the
rounded side down and simply slide the filter into
place.
NOTE:
be sure to keep the filter slider in an upright
position as the filters when inserted do not click into
place and can slide out if the slider is turned sideways
or upside down.
To insert the filter slider into the filter slot, you must
remove one of the end screws
③
by turning it
counterclockwise. You may then insert the filter slider
into the filter slot from either side of the microscope.
Once inserted, replace the end screw by turning it
clockwise.
To move a filter into the light path, slide the filter
slider until the desired filter is in the light path.
NOTE:
the filters have
a “Ʌ” groove on the bottom
and you will hear/feel each
“click” into place.
Fig. 8
②
③
①
Summary of Contents for Versamet 4
Page 2: ......