OM-244 324 Page 25
SECTION 9
−
STICK WELDING (SMAW) GUIDELINES
9-1.
Stick Welding Procedure
stick 2010
−
02
−
151 593
!
Weld current starts when
electrode touches work-
piece.
!
Weld current can damage
electronic parts in vehicles.
Disconnect both battery
cables before welding on a
vehicle. Place work clamp
as close to the weld as
possible.
.
Always wear appropriate per-
sonal protective clothing.
1
Workpiece
Make sure workpiece is clean be-
fore welding.
2
Work Clamp
3
Electrode
A small diameter electrode re-
quires less current than a large
one. Follow electrode manufactur-
er’s instructions when setting weld
amperage (see Section 9-2).
4
Insulated Electrode Holder
5
Electrode Holder Position
6
Arc Length
Arc length is the distance from the
electrode to the workpiece. A short
arc with correct amperage will give
a sharp, crackling sound.
7
Slag
Use a chipping hammer and wire
brush to remove slag. Remove
slag and check weld bead before
making another weld pass.
1
4
3
5
2
7
6
Tools Needed:
Equipment Needed:
Constant Current
Welding Power Source
