UNITED CPC4000, Operation And Maintenance Manual

Page: 11 / 39

©United Surface Solutions • 11901 Burke St, Santa Fe Springs, CA 90670 • (877) 837-4623 • deburring.com
This will recall the Add New Process screen. Press the box next to
Description to enter a new description. Press ENT. Repeat for the Process
Code field. The Process Report given to you by United Surface Solutions
contains all process information, including the process code. United
recommends following all the Process Report data. If a process needs to
be modified to produce different results, contact United Surface Solutions
for no-charge process development. After entering the process description
and code, press CONTINUE to proceed to the Media Data screen.
Press the Media Type A field to enter the media part number. Add a space
then type the height of the media (measured as inches below the top of
the barrel) and press ENTER.
Example: MC-CACC-18x1132 2”
If two types of media are used, enter Media Type B. Press CONTINUE.
The Compound Data screen is much like the Media Data screen. Repeat all
the steps but instead of height, input the compound part number and the
amount of compound required (1/2 Cup, 0.25 Cup, etc.). The measurement
is for operator reference, so any number format is acceptable. Press
CONTINUE to proceed to the next screen.
The Quantities screen is used to input information about parts and water
in each barrel. Enter Water Level by pressing the empty field. Enter it as
“Level” (just covering the media), or +/- a measurement (1”) above or
below the media. This measurement if per barrel. Next, enter the
Parts/Barrel by pressing the empty field next to the label. Simply enter the
number designated on your Process Report. Press CONTINUE to proceed
to the next screen.