Operation Instructions
21
Heating Modes: ‘Standard’ and ‘Economy’
The topside is set by default to operate in ‘Standard’ heating mode. This
means that when the temperature of the water in the spa drops below the
set temperature, the control automatically start heating, bringing Lo-Speed
of Pump-1 (or the Circulation Pump is set/wired for timed operation) on as
necessary.
The topside can also be set to operate in ‘Economy’ heating mode, where
the heater will only maintain the set temperature when Lo-Speed of Pump-
1 is manually activated (if there is no 24hr Circulation Pump), and during
fi
ltration cycles. In ‘Economy’ mode, if the current temperature falls below
the set heat temperature, the ‘Heat’ indicator light will
fl
ash to let you know
that the unit would be heating if not in Economy Mode.
Note:
On spas with Circulation Pumps that run 24 hours a day, economy
mode will not effect heating behavior, the control will continue to heat as
needed to maintain the set temperature.
Switching to Economy Heat Mode
Step 1
Press and the display will read:
(unless the settings are locked)
Step 2
Press and the display will read:
See the following page for information on how to switch to Standard Heat
Mode.
Economy Heat Mode
