Unitech UT-1405, Instruction Manual

Page: 16 / 18

@
sales@utplindia.in +91 7046223333 , 9427301436
www.utplindia.in
www
UT-1405
TEMP. AND DIFF. PRESS. INDICATOR
14
Set the new Password for Configuration [ ] Mode
CONF
2. : CONFIGURATION MODE PASSWORD.
Conf
Scroll the digit by key, Increase by key.
1. : CHANGE PASSWORD MODE PASSWORD
PASS
Password for Mode Parameters
pAsC
Default Password for access Setup mode : 1234
‘Change Password Mode’ Mode will shown by pressing key, after Mode display.
CAL
4.4 Change Password Mode
Configuration Mode default password :
1357
Setup Mode default password :
1111
Set the new Password for Setup [ ] Mode
setp
3. : SETUP MODE PASSWORD.
Setp
Calibration Mode default password :
1234
Set the new Password for Calibration [ ] Mode
CAL1
4. : CALIBRATION MODE PASSWORD.
CAL1
Buzzer Mode default password :
1234
Set the new Password for Buzzer [ ] Mode
BUZZ
5. : BUZZER MODE PASSWORD.
BUZZ
Change Password Mode default password :
1234
Set the new Password for Change Password [ ] Mode
pASC
6. : CHANGE PASSWORD MODE PASSWORD.
pASC
‘Buzzer Mode’ Mode will shown by pressing key, after Mode display.
CAps
4.5 Buzzer Mode
Set this parameter to Enable OR Disable the audible buzzer alarm
2. : ENABLE OR DISABLE BUZZER.
BUZZ
Scroll the digit by key, Increase by key.
1. : CALIBRATION MODE PASSWORD
PASS
Password for Mode Parameters
BUZZ
Default Password for access Setup mode : 1234
Values are : - Enable, - Disable
En D1s
Default value is :
0025
Set the On-off Frequency of Buzzer.
3. : SET BUZZER FREQUENCY.
FREQ
CAUTION
PASSWORD PRECAUTIONS
FAILURE TO COMPLY WITH THESE INSTRUCTION MAY RESULT IN INSTRUMENT DAMAGE
*
*
After Changing old password, all parameter are locked. All Modes are not
accessible without new password.
Changed password should be remembered , it cannot be Reset at site.