Unitech MS840, User Manual

Page: 37 / 65

By scanning the labels from top to bottom sequentially, you may duplicate the rest
of scanners with the same settings.
The following issues should be observed:
The sequence of the strings that the scanner dumped is important. You have to
print the bar code labels and scan them in the same sequence as the one that
the scanner dumped.
When you scan the batch setup labels to configure a scanner, the previous
settings on that scanner are reset to default and then replaced by the settings
contained in the batch labels.
Only the settings that are different from the default values will be dumped. So
the number of labels produced depends on how many settings being changed
compare to the factory default setting.
The settings can be dumped to a PC or terminal only if that PC or terminal
matches the type defined by Device Type of the scanner. The previous
example of “Keyboardless Wedge” as Device Type is equivalent to a PC/AT
interface, so you cannot dump that settings to a system which dose not
support a PC/AT keyboard interface.
The following label let you dump the settings to a PC/AT regardless what kind of
device has been chosen on the scanner.
Dump Settings On PC/AT
You can adjust the length of the dumped strings by combining multiple strings
into one or breaking one string into multiple strings. The following strings have
the same effect as the dumped string listed above:
...I800C06D51DJ8080
80A0O7C005354415254.
You cannot delete any character from or add any character into the strings and the
first three characters (“...”) must present in the first string.
All characters in dumped strings are in upper case. If you see lowercase
characters in dumped strings, change them to upper case.
25