Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
36
Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
37
Command
Command Description
Printer Response
Esc – D-L-n
Select Flash Logo Mode
?
Esc – L-G-n
Load/Record Graphic Logo
none
Esc- L-G-<OxFF>
Stop Loading Graphic Logo
D!X
Esc-L-g-n
Print Graphic Logo
Printer Prints Logo n
Table A.7 – Graphic Logo Commands Table
Please note: The characters ‘-‘ , ‘<’ or ‘>’ are not part of the command string. Decimal
code for Esc is (27).
A.2.3 Generating Graphic Logos
To generate the graphic logo follow these steps:
•
Install the Unitech windows 95/98 graphic only printer driver: <Unitechg.drv >.
Two printer drivers are provided. Use the MP200 Graphic driver to generate 2”
wide logos and the MP300 Graphic driver to generate 3” wide logos. In the
MP200 printer case use the MP200 driver.
•
Use Wordpad or any Windows application to prepare your logo document
From printer Setup of Wordpad application Set the paper margins to 0.12”.
Print your logo document to a file, name it <LOGO.PRN>, using Unitech graphic
•
driver.
•
Go to DOS Window and start the EDIT program.
Go to Start and then select RUN and in the RUN window type EDIT and press
ENTER. The program will open.
•
Open <LOGO.PRN> file in BINARY mode.
Press <Ctrl> <Home> to place cursor at the beginning of file.
Delete everything in the beginning of the file up to but not including the
arrow and the capital letter V next to it.
Move cursor to the end of the file, by pressing control End on your keyboard,
•
There you will see 2 characters - a character which resembles a circle with a
cross attached to it (the FF character) and the line feed character. Delete these
two characters. Add the LOGO RECORD END command string by typing Esc
LG 255. If you never worked with the EDIT program here is how you have to type
it. Press CTRL key and the letter P. Then press the Esc key. Then type LG and then
press the ALT key and type 255.
•
Save the modified <logo.prn> file.
