Install/Remove the Protective Cover
Charging the Battery
Micro SD Card Slot:
1.
Push up SD card holder to unlock.
2.
Flip the card holder open to insert SD card.
3.
Close the card holder and slide down to lock position.
Ensure that it is installed properly.
To install the protective cover, snap its hooks
into the grooves below the gun grip (optional).
2.
Align and insert the battery from the top side.
Press down and make sure to leave half of the
battery strap outside.
3.
Align the hooks on the battery cover with the battery
compartment, then press down the battery cover.
4.
Push the battery lock to the right
to secure the battery.
Grab and pull out the protective cover to remove.
For the regular use, you can charge the terminal for
5 hours to recharge the battery to full capacity.
Charging the terminal with USB Type-C cable
:
Connect the USB Type-C cable to the USB port on
3730E and connect the other end of the USB cable to
AC power adapter, then plug into the electrical outlet.
Note
: It is highly recommended using the RFID USB
Type-C cable and AC power adapter to charge the
terminal.
Inserting Micro SD Card
Lock
Install the Battery
1
.
Make sure the battery lock is in the unlock
position.
Unlock
Checking LED Status
LED
Description
Red Light
■
Battery Charging
■
Twinkling together to indicate
battery low status (less than 15%)
when power is on.
■
Twinkling alternatively to indicate
that battery is not installed or not
installed well when battery charger
was plug-in.
Green Light
■
Battery Fully charged.
■
Barcode scan good read
Blue Light
Message
No LED (Red and Green) display when battery is out.
