1 5
P r e p a r a t i o n
M A B 1 5 0
ENGLISH
NF m e t a l s o r w o r k p i e c e s w i t h a n u n e v e n
s u r f a c e
A special holding device must be used
when drilling into NF metals or into
workpieces with an uneven surface.
NOTE
►
CS Unitec offers a range of
accessories with special clamping
devices for tubes and non-magnetic
materials.
In s e r t i n g t h e t o o l
The machine is equipped with a
3/4" Weldon (19mm) tool mount that can
accommodate core drills up to a length of
1-3/16" (30 mm).
Only use tools with the corresponding 3/4"
(19 mm) Weldon shank.
W A R NING
R i s k o f i n j u r y !
►
Do not use damaged, soiled or worn
tools.
►
Change tools only when the machine
is switched off and at a standstill.
Disconnect the voltage supply.
W A R NING
R i s k o f i n j u r y !
►
After inserting, check that the tool is
engaged securely.
►
Only use tools, adapter and
accessories that match the machine.
In s e r t i n g t h e c o r e d r i l l
Before mounting, clean the Weldon
shank of the core drill and tool mount (2)
of the machine.
Check the supply connection for
the lubrication (hose of the pump
bottle (C) must be attached to the
connecting nipple (4)).
Extend the tool mount (2) with the
hand lever (6) until both Allen screws
in the tool mount (2) are freely
accessible.
Loosen both Allen screws in the
tool mount (2) using the SW 4 offset
screwdriver supplied.
NOTE
►
Insert the appropriate ejector pin (A)
before inserting a core drill.
Insert the core drill (1) from below
into the direct tool mount (2) of the
machine.
Tighten both Allen screws in the direct
tool mount using the SW 4 offset
screwdriver supplied
W A R NING
R i s k o f i n j u r y f r o m i n c o r r e c t l y i n s e r t e d
t o o l !
►
Check for secure and correct seating
of the core drill.
Summary of Contents for MAB 150
