UNIS Ultra Moto VR, Operation Manual

Page: 92 / 99

Ultra Moto VR Manual
03/03/2020
91
compressor. It should be add power stabilizer or booster, to make the use voltage up to
standard voltage.
4.6 By using, the air holder of the air compressor will condense a small amount of
moisture content, so must be drained regularly, generally drainage once a week. Switch off
the power before draining, open the exhaust valves to drain the gas in the air holder, and
then unscrew the bottom seal lock of the air holder, after draining water, re-installed can
use.
4.7 By using, because in the air has dust, so entering air silencer will be washed once a
week. Switch off the power before washing, switch off the silencer, then switch off the end
closure of the silencer, popped the inside sponge, clean thoroughly with clean water, airing,
re-installed can use (also car replace new sponge).
4.8 On the top of the tunableness component pressure controller has an adjusting screw,
can be used to regulate plus-minus psid. Manufacturers have been adjust the outage
pressure property before the compressors leave factory, the users must not adjust
according to their wishes, otherwise may be will overstep the design parameter of the
complete appliance, damage machine set, or lead the air compressor can't running
normal.
4.9 Compressor with thermal protection and over-current protection: when the motor
overheated, the thermal protection will automatically disconnect; when the motor stall, the
voltage too high, over-current protection will automatically disconnect and both will be
automatically reset. So please pay attention to whether the circuit is free-flowing or not
when checking.
10.5 Conserve And Protect
5.1 To ensure safety, the compressor work is prohibited on touch any component from the
appliance.
5.2 This compressor is oil-free compressor, is prohibited on add oil to lubricate.
5.3 To use this compressor, the ambient temperature is from 5
℃
to 40
℃
5.4 It is ban to watering towards the complete appliance while washing the compressor,
please use soft dry cloth to rub-up the dust on the top. be careful not damage the
component.
5.5 After using, please cut off the power switch, switch off the air supply.