CARE AND MAINTENANCE
(continued)
Repair Parts
When repair parts are needed, contact the dealer from whom the range
was purchased. In case your range was purchased from a source other
than an appliance dealer, you may prefer to contact the manufacturer at
the address shown in this manual.
Moisture
During the initial heat-up of your range, the heat mixing with the cooler
air in the oven cavity may produce fogging of the door glass or a collec-
tion of water on the door. To prevent this, open the oven door for the first
few seconds of initial oven heat-up. This will allow the moist air within
the oven to escape, without the forming of visible moisture on the range.
The amount of moisture will depend upon the humidity of the air and wa-
ter content of the food being cooked. Fogging and even dripping water
will usually occur in geographic locations of high humidity.
BURNERS AND CAST-IRON GRIDS
• These parts can be removed and cleaned with appropriate products.
• After cleaning, the burners and their flame distributors must be well dried and
correctly replaced.
• It is very important to check that the burner flame distributor and the cap has
been correctly positioned - failure to do so can cause serious problems.
• In appliances with electric ignition keep the electrode clean so that the sparks
always strike.
Note: To avoid damage to the electric ignition do not use it when the
burners are not in place.
40
Summary of Contents for UGP-24V PC1 S/S
Page 21: ...21 WALL CLEARANCES continued...
Page 46: ...UGP 24V PC1 S S WIRING DIAGRAM 46...
Page 48: ...48 UGP 24V PC1 S S PARTS DIAGRAM AND LIST...
Page 53: ...NOTES 53...