bath
o
vision - installation manual
page 6
vide a suitable spacer to raise the base of the TV such that it is centralised in the cavity
cutout. Carefully present the TV to the cavity cutout and gently slide the TV into the re-
cess. Make sure that all the cables are clear and free of the sides and top and base of the
cutout. Push the TV home against the wall or tiles making sure that the sealant on the rear
of the mirror is pressing against the wall and that a waterproof seal is achieved all round
the rear of the mirror. Remove or smooth out any excess sealant around the edges of the
mirror as soon as practical. Any minor gaps remaining may be filled with the sealant. A
degree of limited pressure should be exerted on the front of the TV mirror whilst the seal-
ant sets into position. The special silicon sealant supplied will retain a degree of flexibility
when fully set. Maximum adhesion will be achieved after approx. 24 hours. Should you
wish to remove the TV from the wall after the silicon sealant has set please contact the
company for advice. Once sealed, never attempt to prise the TV off the wall.
Verify the connections
7.
Switch on the mains electricity supply to the television and switch on the television.
Test that the held controller is working correctly and that the touch screen controls are
operating correctly. The bathovision™ is ready for the program set up procedure. (For
the program set up procedure - see the bathovision™ operating manual).
Figure 5.