Unipro 811050, Mounting And Using Instructions

Page: 12 / 27

12
3/ Overview
Policarbonate body, bowl and fastening clips
Built-in electronic ballast
Removable bowl from body
Side cable entry with grommet
Cast seal: IP65
Fixing screws and pegs included
Conformity to the essential requirements
of the European directive(s) applicable to
the product
Non-dimmable luminaire
Luminaire suitable for direct mounting
on normally flammable surfaces
Luminaire with limited surface
temperatures
Imported by UNIFIRST
ZI La Borie - 43120 Monistrol sur Loire - FRANCE
Made in PRC - Non contractual pictures
4/ Safety instructions
Warning! In order to reduce the risk of electric shock,
injury and fire when using electric appliances, read
and apply following basic safety instructions:
This lamp marked with
IP 65
is dust-proof and
protected against water jets and is suitable for
use in wet rooms. The use of this lamp in covered
outdoor areas is allowed.
The electrical mains supply used to feed this
lamp must comply with the relevant regulations
and must have an earth connector (the power
connector cross-sections should be 1.5 mm²
minimum).
The luminaire should be installed by a qualified
electrician only.
Changing or modifying the mechanical or
electrical structure of the lamp is prohibited.
Keep electrical equipment safely out of the reach
of children.
This fluorescent lamp is non-dimmable and
should not be used with a dimmer.
The fluorescent lamp is suitable for direct
mounting on normally flammable fastening
surfaces.
Always observe the technical data on the rating
plate of product and in the assembly instructions.
This unit is in conformity with European
regulation and standards in effect (electric safety,
environment) when it is delivered and will be
kept safe if the instructions of this manual are
respected and the repair carried out by qualified
personal. If the product contains plastic bags
when delivering, these must be kept away from
children due to the risk of suffocation.
5/ Package contents (Fig. 1)
a) Body and reflector
b) Fluorescent tube
c) Bowl
d) Fixing screws, washers, pegs and metallic
supports
e) Cable gland
f) Fastening clip
Check carefully that all the accessories and parts
are complete and that they are in good condition
when unpacking. Do not install or set in operation
a damaged lamp or with missing parts.
6/ Assembly and electrical connection
• Assembly
- Make sure the connection cables are
disconnected from the power supply before
assembly, maintenance or repair work (cut the
power supply at the distribution board or remove
the fuse). Secure against being switched back on.
- Check the walls and ceiling for other hidden
electrical cables when drilling.
- The lamp must not be installed at less than 2 cm
from any wall (wall or ceiling).
1) Unmount the reflector by pinching the plastic
clamps (Fig. 2) and remove the fluorescent tube(s)
by turning a quarter turn.
Where necessary, remove the transport protection
from the tubes.
2) Fix the metallic supports to the wall or to the
ceiling with the supplied screws, washers and
pegs. Install the lamp body by pressing it onto the
metallic supports (Fig. 3 and assembly drawing).
3) In case of cable gland is not assembled on the
lamp, follow the instructions below:
There is a predrilled opening on the side of lamp
to allow the power cable entry.
If the lamp is broken or damaged, do not use it
anymore and contact an autorized agent!
F
D