24
Battery change
To replace batteries
When the batteries reaches 2.2 V the low
battery symbol will be shown at the bottom of
the display:
You can continue to use the UniTire until the
last of the 4 ’cells’ in the battery symbol are
turned off.
The batteries are located inside the box. Put
UniTire on the table with the rear side up.
Unscrew the two screws and remove the rear
part of the box by lifting the end with the two
screws. Here you will see a battery holder with
two standard Alkaline 1.5 V AAA batteries.
Please replace them with two new ones
of high quality.
Please do not dispose the batteries in the
nature. Use the official return channels
for them!
Be careful to put them in with the right polar-
ity. If you should by accident put them in the
opposite direction, you will not hurt UniTire or
the batteries.
When assembling UniTire again, slide the rear
part into the front part and center it before
closing it.
Please do not over tighten the two
screws!
Cleaning
To clean the case, display, and buttons
The exterior surfaces of UniTire products are
made from solid anodized aluminum, plastic
overlay, and stainless steel.
They are designed to be easily wiped clean
with a dry, lint free cloth.
Greasy marks should be removed by light rub-
bing with a slightly damp cloth and a trace of
proprietary glass cleaner.
Do not use any other solvent or abrasive
based cleaners.
Ensure that no liquid enters the box and
that the product is completely dry before
reuse.
Maintenance
M a i n t e n a n c e
