16
Digital gauge view in Stealth mode
Three arrows means more than 100% away,
two arrows means more than 50% away
and one arrow means more than 10%
away. If you are within 10% of the target,
no arrows will be shown.
Analog gauge view in Stealth mode
Also in Stealth mode the analog gauge view
has less information than the digital gauge
view. Here it shows a limited area of the
scale, the actual tire (FL = Front Left) and
no actual value as a number.
Also in the analog gauge view in Stealth
mode, the functions are exactly the same
as in Sequence mode:
To start in Stealth mode, turn UniTire on by
keep pressing the
left
button (
3
).
Measure the tire pressure in the defined se-
quence order, and save each value by pressing
the
right
button ( ).
If you want to start over with the current
sequence, press and hold the
left
button (
3
)
down until the circle shows the first tire again.
When you save the measured values
in Stealth mode, the actual values are
stored in the memory, so you will be able
to see them in recall mode.
Use Stealth offset in pressure mode
When Stealth mode is enabled, an offset can
be added to the current pressure value in
”Pressure mode”. This is to confuse prying
competitors.
For example:
If the offset is entered as -0.20 bar (see
”STEALTH OFFSET SETUP” on page 20) and
the real pressure is 1.65 bar, the value shown
in the display is 1.45.
Pressure mode view in Stealth mode
If a stealth offset is entered in setup mode,
the pressure value shown is not the actual
pressure value. If no pressure is applied, a
question mark is shown
to avoid the stealth
offset being visible
.
The values in the history list still shows
the real pressure values. It is only the
current pressure value with the large
digits that is affected.
Operating UniTire
R e f e r e n c e
G u i d e
