| 37
C64.65201 Issue 3
Jun 2019
Refitting is achieved by hanging the correct module (RYG or YY) onto the mounting
rail ensuring the plastic module spacers are in the position noted before removal and
then pushing the locking levers down past the horizontal until the slot in the lever
has fully engaged with the lock pin on the inside of the frame.
Lever position shown without module fitted for clarity
BOTH LOCKING LEVERS MUST BE FULLY ENGAGED.
CHECK THE MODULE IS LOCKED IN PLACE BY TRYING TO PULL THE
BOTTOM OF THE MODULE AWAY FROM THE FRAME - IT SHOULD NOT
MOVE
Ensure the plug couplers are stowed correctly in the support brackets and any cable
ties are replaced.
If the module is simply to be tilted back to facilitate cleaning etc., sufficient cable is
available to allow the module to be swung on the pivot bar without disconnecting
the plug coupler.
End of Life Disposal
Wherever possible the component parts and complete assemblies of the Unipart
Dorman CLS LITE are designed to be disposed of in accordance with the
requirements of the Waste Electronic and Electrical Equipment Regulations 2006.
Please contact Unipart Dorman for full details of the procedure to be undertaken
when a signal is permanently withdrawn from service for disposal.
