REPLACEMENT OF ASSEMBLIES - MTJ/MRJ SERIES
- any furthermentioned modifications, without our written consent, will void our liability in respect of the linear unit,
- before any operation make sure that the module is disconnected from the power grid to prevent possible injuries
caused by the electrical current or moving parts,
- MTJ 40: due to the precise fit between railguide MR 12 and carriage block Mini MR 12 both need to be replaced
at the same time even if only one of them fails.
STEP 1:
remove the screws.
STEP 2:
remove the cover plate.
Note:
attaching the cover plate is conducted in
the reverse order.
Removing the cover plate
Note:
all screws (except set screws) must be glued (Loctite 243) and screwed with
the torque specified in the table on page 1.005.0 unless written otherwise at the
individual steps.
Replacing the protection strip
STEP 1:
remove the cover plate as described in
chapter “Removing cover plate”.
STEP 2:
loosen the set screws that hold the
protection strip and remove it.
STEP 3:
place new protection strip on top of the
module and attach it to one end block.
STEP 4:
slide the carriage as close as possible to
the end block to which protection strip is attached
and screw the cover plate over the protection strip
on the carriage.
Note:
when placing the cover plate back on the
carriage watch for the lubrication nipple.
STEP 5:
slide with a hand over the protection strip
towards the loosened end to tighten it. At the end
block hold protection strip tensioned and tighten
two set screws to fix the strip.
MTJ MRJ Series
MANUAL
1.130.0
STEP 1
STEP 2
STEP 2
STEP 5
The specifications in order to improve the products in this catalogue are subject to change without notice.
