(3)
Fit the correct size Knurled drive roller for Gas Less
Flux Core wire
(4)
Place wire onto spool holder - (spool retaining nut is
left hand thread ) Feed the wire through the inlet guide
tube into the drive roller.
(5)
Feed wire over the drive roller into the outlet guide
tube, Push the wire through approx 150mm.
1 (+)
2 (-)
1.
Insert the earth cable plug into the required polarity and tighten - positive (+) for flux cored wires wires.
2.
The weld power cable goes into the opposing negative (-) socket.
VIPER 120 SYNERGIC MIG Welder |
13
GASLESS MIG INSTALLATION
