Unimac 13 Inch, Important Instructions

Page: 5 / 5

Page 5 of 5
(1-05-3)
5. Remove guide ribbons by removing staples. Refer
to Figure 11.
6. Remove finger guards.
7. Remove hardware attaching rollers to right side,
including screws, sprockets, collars and bearings.
Refer to Figure 12.
8. Remove rollers by pulling through to the left side
of the machine.
9. Use a forklift to support the cylinder before going
any further.
NOTE: Cylinder weighs approximately 300-400
pounds. It must not be tipped.
10. Disconnect electrical wires from the pressure
switch, fan motor, drive motor and side panel
switch. Pull wires through to the left side of the
machine.
11. Remove right frame. Refer to Figure 1.
12. Remove cylinder from machine using forklift to
support.
13. Remove left frame. Refer to Figure 1.
14. Reassemble press using reverse order of these
instructions.
To avoid serious injury use caution when
separating press. Sections can become
unstable if not supported correctly.
W432
WARNING
FWF68N
1 Screw
2 Bearing
3 Sprocket
4 Collar
Figure 12
1
2
3
4