13. Cooling Vents -
These vents are used for proper cooling. Never block these
vents when installing the amplifier or other associated equipment and keep
them clean at all times. Air must flow unimpeded through these ports.
14. Channel 1-2 Balanced 1/4” TRS & XLR Input Connectors -
These connectors
accept input signals on balanced TRS and XLR input plugs. Connectors for
each channel are in parallel, the unused connectors may be used for “loop
through” connection to other amplifiers.
TRS pin setting: Tip/signal positive, Ring/signal negative, Sleeve/ground.
XLR pin setting: Pin-2/signal positive, Pin-3/signal negative, Pin-1/ground.
For MT-2000II, it also allows to use Euroblock input connectors. Euroblock pin
setting: (+): signal positive - Hot, (-): signal negative – Cold; ( ): ground
15. Amp. Mode Selection Switch -
This switch allows the amplifier operating mode
from either stereo or mono bridge selection. Amplifiers are factory-configured
for Stereo Mode. See section on Mode Selection for more information.
16. Fan Outlet Ports -
MT series equipped with one single 2-speed cooling fan.
Cooling air enters the amplifier through the front grills and exhausts through the
fan. Be sure not to block these ports when installing the amplifier or other
associated equipment. Air must flow unimpeded through these ports.
17. Fuse Holder -
This holder houses the external fuse. Always replace with the
exact same type fuse, otherwise instructed to do so by an authorized audio
service technician.
18. A/C Power Input -
IEC AC power inlet connector, plug this cable in to a
standard 110V or 220V wall outlet. Be sure that supplied voltage matches that
of the required voltage of your amplifier. Never plug your amplifier in to a wall
outlet that does not match the required voltage of your amplifier, serious
damage may occur to your unit.
19. Ground Lift Switch (MT-1000 only) -
This switch is used to disconnect the
internal ground signal from the amplifier's chassis ground. This may reduce
the buzz that is caused from an electrical 50Hz/60Hz cycle.
20. Channel 1-2 Output Jack / 5-way Binding Post -
Connect to your speakers
input jack. Red is positive signal and Black is negative signal.
MT-1000/2000II REAR PANEL
page 4
Important Precautions Introduction
Front Panels
Set Up Operating Modes Protection Features Specifications
Rear Panels
UNiKA
MT-1000/MT-2000II
Figure
4
Figure
3
Balanced
Balanced
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: REPLACE WITH SAME TYPE FUSE AND RATING
120V-, 60Hz, 840VA
T250V, 7A, L
17
18
15
14
16
20
19
13
13
Balanced
Balanced
STEREO
AMP MODE
BRIDGE
CH 1 INPUT
CH 2
CH 1
_
_
+
+
CH 2 INPUT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ATTENTION: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
CAUTION: REPLACE WITH SAME TYPE FUSE AND RATING
120VAC
60Hz
1200VA
FUSE
T250V
10A L
CH 2
BRIDGE
4 Ohms/Ch
Minimum
Stereo Mode
8 Ohms
Minimum
Bridge Mode
CH 1
_
_
_
+
+
+
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK DO NOT EXPOSE TO RAIN OR MOISTURE
16
20
14
15
17
18
13
13
