Unika MT-1000, User Instructions

Page: 8 / 12

page 7
Figure 13 Typical Stereo Output Connections
SPEAKERS
4 OHM MINIMUM
SPEAKERS
4 OHM MINIMUM
OPERATING MODES
STEREO OPERATION :
Page 7 / Figure 13 details an example of a typical stereo set-up. Connect your inputs into channels one and two of the amplifier.
Connect your speakers to the outputs on the rear of the amplifier. Be sure that your front gain controls are turned down to their lowest level (fully counter-
clockwise). Turn your amplifier on. Turn your input source level up. Use your front gain controls to regulate the output volume. Be sure not to raise the volume to
the clip level, however an intermittent clip signal is acceptable.
MONO BRIDGE OPERATION :
Page 7 / Figure 14 details a mono bridge set-up. Be sure your amplifier and all other audio equipment are powered down.
Press the Stereo/Mono Bridge switch to the Mono Bridge position. Connect an input signal to channel one. Connect your speaker across the red output binding
post on the rear of your amplifier. Turn your equipment on (your amplifier should always be the last item you turn on). Apply an input source signal to your
amplifier. Use the channel one gain control to regulate your amplifier output.
Important Precautions Introduction Front Panels Rear Panels Set Up Protection Features Specifications
Operating Modes
UNiKA MT-1000/MT-2000II
Balanced Balanced
STEREO
AMP MODE
BRIDGE
CH 1 INPUT CH 2 CH 1
_ _
+ +
CH 2 INPUT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN ATTENTION: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
CAUTION: REPLACE WITH SAME TYPE FUSE AND RATING
120VAC
60Hz
1200VA
FUSE
T250V
10A L
CH 2
BRIDGE
4 Ohms/Ch
Minimum
Stereo Mode
8 Ohms
Minimum
Bridge Mode
CH 1
_
_
_
+
+
+
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK DO NOT EXPOSE TO RAIN OR MOISTURE
CH-1 Input
CH-2 Input
MT-2000II
REAR PANEL
STEREO
AMP MODE
BRIDGE
SPEAKERS
8 OHM MINIMUM
Balanced Balanced
STEREO
AMP MODE
BRIDGE
CH 1 INPUT CH 2 CH 1
_ _
+ +
CH 2 INPUT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN ATTENTION: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
CAUTION: REPLACE WITH SAME TYPE FUSE AND RATING
120VAC
60Hz
1200VA
FUSE
T250V
10A L
CH 2
BRIDGE
4 Ohms/Ch
Minimum
Stereo Mode
8 Ohms
Minimum
Bridge Mode
CH 1
_
_
_
+
+
+
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK DO NOT EXPOSE TO RAIN OR MOISTURE
CH-1 Input
Only MT-2000II
REAR PANEL
STEREO
AMP MODE
BRIDGE
Figure 14 Typical Mono Bridge Set-Up