Front Panel Control
Figure
1
page 5
1
UNiK A
Introduction
Rear Panel
Set Up
Operating Modes
Protection
Specifications
Front Panel
SIGNAL
SIGNAL
CLIP
CLIP
CH-1
CH-2
MS-550
POWER
ON
OFF
10
10
0
0
PROFESSIONAL
STEREO
AMPLIFIER
UNiK A
2
3
4
5
6 7
8 9
1
.
Power
Switch
-
This
switch
is
used
to
control
the
units
main
power
.
2
.
Cooling Vents -
These vents are used for proper cooling. Never block these
vents and keep them clean at all times.
3
.
Channel
1
Gain
Control
-
This
rotary
knob
is
used
to
control
the
output
signal
of
channel
1
.
Turning
the
knob
in clockwise
direction
will
increase
signal
output
.
4. Channel 2 Gain Control -
This rotary knob is used to control the output
signal of channel 2. Turning the knob in a clockwise direction will increase
signal output.
5.
Power Indicator -
This blue LED will glow when main power is applied to the unit.
This light may continue to glow brief y after main power has been turned off, this is
normal.
6. Channel 1 Clip Indicator -
This red LED will begin to flash when channel 1
begins to overload (clip). At this point channel one will begin to distort. Under
heavy clipping activity lower the channel 1 gain control to reduce the risk of
damage to your speakers and amplifier. This LED may glow when the unit has
been turned off, this is normal.
7. Channel 1 Signal Indicators -
These green LED will glow according to the
average signal output.
8. Channel 2 Clip Indicator -
This red LED will begin to flash when channel 2
begins to overload (clip). At this point channel 2 will begin to distort. Under
heavy clipping activity lower the channel 2 gain control to reduce the risk of
damage to your speakers and amplifier. This LED may glow when the unit
has been turned off, this is normal.
9. Channel 2 Signal Indicators -
These green yellow LED will glow according
to the average signal output.
MS550 / MS750 / MS1050 / MS2050 / MS3050
