7.9 Configuration tab
Follow these steps to load new firmware:
1. Press the “Select Firmware” button to choose the firmware file to load in to the SQM as shown in Figure 7.29:
Figure 7.29: Firmware selection
2. Select the desired firmware file then press “Open”.
3. The “Load firmware” button will be enabled and you can press it now to start loading the firmware in to the
SQM-LU. The status bar will indicate successful completion when the firmware has been completely loaded.
7.9 Configuration tab
The “Configuration tab” shows the factory-set calibration values.
Calibration is performed at the Unihedron factory. A new calibration using a calibrated light source and darkroom can
be performed by following the instructions on the right side of the screen. The calibration report can be logged to a data
file and also printed out from this screen.
Figure 7.30: Configuration tab
Warning confirmations as shown in Figure 7.31 and Figure 7.32 are shown when trying to calibrate the unit yourself:
Unihedron SQM-LU Operator’s Manual -
20170728
35
Summary of Contents for SQM-LU
Page 2: ......