8
6 External
Optional
accessory connection
1 Mechanical actuator: Limiter NC (
GREEN
)
connect with actuator Green signal wire.
2 Solenoid valve (12V or 24V): Limiter NC (
GREEN
) connect with solenoid valve PIN1.
3 Pedal controller: Connect limiter NO (
YELLOW
) wire with controller
Red
wire.
Controller black wire connect to Ground. (
NOTICE
: Please follow below diagram ONLY.)
Take 24V solenoid valve as an example:
Please connect limiter
GREEN
wire to
PIN1, connect PIN2 to battery Ground.
PIN3 No need connection. At safe
driving speed, fuel flows through the
valve. If driving speed reaches speed
limit, valve shall stop fuel flow so as to
reduce speed. When speed is below
speed limit, valve shall enable fuel flow
again.
Actuator has 3 wires. Red for battery
P, Yellow for Ground. Green is
signal wire.
Connect limiter
GREEN
wire to actuator
Green
wire, the steel rope shall reach
out around 5CM, disconnect device
Yellow wire, the steel rope shall pull
back around 5CM.
When speed reaches, device Yellow
wire has no power, then actuator pull
back the steel rope.
