Unigas IDEA LG280, Manual Of Installation - Use - Maintenance

Page: 25 / 89

C.I.B. UNIGAS - M039132CD
25
If you modify the blast tube length you have to modify also the combustion head length by reading the following instructions.
1
Remove the screws V1 and V2 as shown in Fig. 13.
2 Lower the terminal part of the combustion head, by moving it with a slight circular movement, until the holes will match (Fig. 14)
and tight the screw shown in Fig. 15.
3 Adjust cables length by pulling them very slightly paying particular attention not to disconnect the ionisation cable to the electrode.
4 Fix the combustion head again (See “Removing the combustion head”).
Gas Train Reversal
The gas train can be fit either on the left and on the right. Follow these instruction..
1
Remove the plastic hook G to release the rod T (Fig. 16) .
2 Take the screws V1 , V2 , V3 , V4 , VT1 and VT2 off (Fig. 16).
3 Take the ignition cable CA off of the transformer .
4 Disconnect the connector CR from the printed cirduit ( Fig. 17).
5 Take off the flange and the combustion head together (Fig. 19 ).
Fig. 11 Fig. 12
Fig. 13
Fig. 14
Fig. 15
V2
V1