Unigas HTP512A, Installation, User'S, And Maintenance Manual

Page: 33 / 60

C.I.B. UNIGAS - M039219CA
33
Example (Fluidics): as for over 100kg/h nozzles, the 80% of the nozzle flow rate can be obtained with a return pressure at about 18bar
(see Fig. 30).
Oil Flow Rate Settings by means of Berger STM30.. actuator
1 Once the air and gas flow rates are adjusted, turn the burner off, switch it on again by turning the CM switch to the oil operation
(OIL, on the burner control panel).
2 with the electrical panel open, prime the oil pump acting directly on the related CP contactor (see next picture): check the pump
motor rotation and keep pressing for some seconds until the oil circuit is charged;
3 bleed the air from the M pressure gauge port (Fig. 31) by loosing the cap without removing it, then release the contactor.
Fig. 31
4 Before starting the burner up, drive the high flame actuator microswitch matching the low flame one (in order to let the burner ope-
rates at the lowest output) to achieve safely the high flame stage .
Fig. 30
Suntec TA.. Danfoss KSM.. Suntec T..
FLOW RATE kg/h
DIMENSIONS Min Max
40 13 40
50 16 50
60 20 60
70 23 70
80 26 80
90 30 90
100 33 100
115 38 115
130 43 130
145 48 145
160 53 160
180 59 180
200 66 200
225 74 225
250 82 250
275 91 275
300 99 300
330 109 330
360 119 360
400 132 400
450 148 450
500 165 500
550 181 550
600 198 600
650 214 650
700 231 700
750 250 750
800 267 800
CP
VR
M
M
VR
M
VR