UIC680 Programmer’s Manual
UDN PM090-C2 Rev. 2.3
Command
<35><35><0E><1A><1E><00><0A>
Response ‘^’
–
Acknowledgement
‘*’ – Cannot execute (e.g. out of range)
‘!’ – Bad parameter (e.g. incorrect length)
•
B (42H) – Buzzer Beep control
COMMENT
Used to let Buzzer beep under user’s control.
B[Type, 1~4 bytes] – [Count, 1 byte][Tone, 1 byte(optional)][OnDuration, 1
byte(optional)][ShortDuration, 1 byte(optional)]
[Count]
0 (30h, ASCII Hex) – long beep
1~9, A~F(31h~39h 41h~46h, ASCII Hex) – 1~15 short beeps
Important:
Once ‘B0’ command starts beeping, NO command can STOP it–unless users send a
“Reset” command to stop it.
[Tone]
For adjusting the frequency level, 00h~FFh(high
→
low).
[OnDuration]
The duration of a beep; time unit is 10ms, 00h means 10ms, FFh means 2560ms.
[ShortDuration]
The interval between 2 beeps in unit of 10 milliseconds; 00h means 10ms, FFh means
2560ms.
NOTE
If [Type] parameter is omitted, reader will treat it as the ONE SHORT Beep
command.
RESPONSE ‘^’
–
Acknowledgement
‘*’- Failed, the reader is in Self-Arm mode. The antenna power cannot be
turned on.
5-9
