21
Adjusting the conveyor belt tension
Eventually the conveyor belt may become loose due to operating load. In this case the tension of
the conveyor belt must be readjusted.
Put the conveyor belt into the operating position.
Slightly loosen the fastening screws (1) on both sides of the conveyor mechanism.
Loosen the counter nuts on both tension adjusting screws (2).
Tighten the upper part of the conveyor mechanism by evenly turning both tension
adjusting screws.
When you adjust the correct tension of the conveyor belt, tighten the tension adjusting
screws (2) with counter nuts.
Tighten the fastening screws (1) on both sides of the mechanism.
It is important to make sure that the belt is running along the middle of the roller and not on one
side only. If the belt is running on one side only, the position of the upper roller must be correctly
readjusted so that the rollers are parallel to each other!
8.
Stopping the machine
Before the machine is stopped, disengage all pressurized hydraulic functions.
To achieve this, move all operating levers into neutral position.
Tractor drive with a cardan coupling
Disconnect the cardan coupling of the tractor.
Before disconnecting the cardan coupling, position the throttle lever of the tractor to a minimum
and disengage the cardan function.
TRANSPORT
Lift table
The lift table must be moved into the transport position.
See lift table (reverse direction of extension for operating position).
Conveyor belt
The conveyor belt must be moved into the transport position.
See conveyor belt (reverse direction of extension for operating position).
Before the machine is transported, disengage and disconnect the cardan shaft from the
generator.
1
2
