16
Positioning of the conveyor belt into operational position
Disconnect the conveyor belt
(1) under the manual winch and lower it to an angle of 35°
using the manual winch
Extend the conveyor belt with the lever (2) on the control panel into its final position (the
hydraulic cylinder is fully extended), the awning must be appropriately taut
Before operating, check the angle of the conveyor belt with the designated measurement
scale on the conveyor belt
Belt shift +/-
15°
Firewood length
Turning angle
25 cm
t
o 15°
33 cm
t
o 15°
40 cm
to 7.
5°
50 cm
0°
60 cm
0°
Push the lever on the lower part of the conveyor belt with your foot
Manually turn the conveyor belt into required direction
Remove the foot from the lever to release it and turn until the pin is locked in position
2
1
