20
Electrical connections
WARNING! Electrical connection of the machine
to the power supply must ONLY be carried out
by a qualified electrician.
WARNING! Electrical lines must be established
in full respect of CEI standards.
WARNING! Before establishing the electrical
connection, make sure that the power supply is
off. Also ensure that it is not possible to
reconnect the power during the operation.
WARNING! The power supply voltage must be ±
10%
To carry out the electrical connections of the machine to the
power supply, carry out the following procedures:
•
use suitable equipment to check the efficiency of the
grounding system;
•
check that the voltage and network frequency correspond
to those of the machine (see identification label);
•
open the door of the electrical panel;
•
remove the plastic screen of the electrical panel using a
star screwdriver;
D5
D7
A
D7
B
•
pass the cables inside using the power supply cable inlet
D7A which connects to the main switch D5;
•
refer to the wiring diagram and connect the cable to the
main switch D5.
2222 - 2242 - 2522 - 2542 - 2842 - 3342
POWER SUPPLY CABLE
(at customers at care)
POWER SUPPLY CABLE
(at customers at care)
