170720 Rev. B
Page 4
2.2
Set the Intek steamer on the stand upper shelf as shown and re-attach the drain pan
rails using four 3/8-16 5/8” hex head machine screws (Item 9) and four 3/8 washers (Item 10).
Start the screws into the bottom of the steamer, but do not fully tighten them until step 2.4.
2.3
[NOTE: the following step is optional – the machine screws are not needed for structural
integrity of the steamer or the stand.]
Reinstall the four smaller hex head machine screws that were removed from the underside of
the steamer through the holes in the edges of the stand shelf. Two screws are used on the left
and on the right underside of the steamer. There are 6 holes on each side of the shelf to match
the patterns on the three Intek Steamer models (4-Pan and 6-Pan electric; and 5-Pan gas).
Steamer
with legs removed
Drain Pan
Slides (2)
3/8-16 5/8” Hex
Head Screws
and Washers
