170720 Rev. B
Page 1
I
NSTRUCTION
S
HEET
Intek Steamer Knockdown Stand
Assembly and Steamer Mounting
Introduction:
The 170944 Intek Steamer Stand is shipped in a compact, knockdown form. Assembly on site
is required before attempting to mount the steamer(s). The instructions below will guide you
through the process. All of the hardware required to assemble the stand and mount the
steamer(s) is included.
1.0
Stand Assembly
1.1
Determine the shelf position locations most appropriate to the location. There are two
shelves supplied with the stand and both must used to provide proper stability. The lower shelf
always mounts in the bottom position. The upper shelf mounts in one of four positions,
depending upon whether a single steamer is being mounted or a pair of steamers are being
double-stacked. The upper shelf always mounts in the topmost position when a pair of
steamers are mounted.
1.2
The above figure shows the shelf orientation for a single steamer, where the cutout in
the lower shelf is turned to the back of the stand. For a double-stack stand, turn the shelf so the
cut-out faces to the front.
