TOTAL SECURITY FEATURES
The system incorporates total security features which is particularly offered by the
patented
Code Learning Technology (CLT)
. With the CLT code, aside from prevent-
ing easy deactivation of the system, it also totally prevents unauthorized learning of
transmitters. The factory preset of the CLT code is at 1 (first digit), 0 (second digit).
NOTE
: In the following procedures, the LED will flash in sync with the siren. And also,
begin performing the succeeding step within 5 seconds.
Emergency Disarm
is a back-up method of disarming the system in case the
transmitter is lost or stolen. Performing emergency disarm automatically sets the
system in
passive arming and entry delay mode
. In entry delay mode, the unit
will trigger 10 seconds after opening a door.
1. Open the car door using your key and turn ignition switch ON.
2. Press the over-ride switch the number of times corresponding to your
first
security code number.
3. Turn ignition switch OFF and then ON again.
4. Enter the
second security code number.
5. Turn the ignition switch OFF.
6. The system is now disarmed.
NOTE
: Should you enter a code incorrectly, wait for at least 10 seconds and start
again from step 1. System automatically exits entry delay mode upon using
a valid transmitter.
NOTE
: You will be given a wallet sized card with your emergency disarm code
number by your installer.
Changing Security Code
ensures higher level of security which is essential in
performing emergency disarm and learning new transmitters.
1. With the alarm in disarm mode, turn ignition switch ON then OFF.
2. Press transmitter button 2 twice. The
siren will long chirp.
3. Turn ignition switch ON.
4. Enter
new first security code number
via over-ride switch.
(Choose from 1 to 255)
5. Turn ignition switch OFF.
6. Enter
new second security code number via over-ride switch.
(Choose from 0 to 255).
7. Siren will chirp once indicating successful change of security code. On the other
hand, 2 chirps denote unsuccessful change of security code.
Learning New Transmitters
must be performed if you need to replace a lost or
stolen transmitter. The system will erase all previous transmitters and has the ability
to learn a maximum of 5 transmitters.
1. With the alarm disarmed, turn ignition switch ON.
2. Enter
first digit security code
via VECLP switch.
3. Turn ignition switch OFF.
4. Repeat steps 1 to 3. This time enter
second digit security code. The siren will
long chirp.
5. Press either button 1 or button 2
twice within 10 seconds
.
6. To learn more transmitters, repeat previous step.
7. Learning mode will terminate once ignition is switched ON or 10 seconds of
inactivity has occurred or the maximum of 5 transmitters have been learned.
NOTE: Siren will chirp once
to confirm new transmitter is learned and
twice
if trying to
learn a learned transmitter. Upon exiting learning mode, siren will chirp a
number of times corresponding to the number of transmitter stored in the system.
