17
Setting Up a Scan
You can have the receiver automatically cycle through the enabled channels.
Open the menu, and scroll down to select
1.
Scan time
.
Use
2.
RIGHT
or
LEFT
to select the amount of time you want the receiver to stay on each camera.
Choose
5 seconds
,
10 seconds
,
15 seconds
, or
20 seconds
. To turn off the scan and stay on the
current channel, select
Off
. To set the receiver into quad display, select
Quad
(see Using Quad
Display on page 18).
Double-check the channel settings (
3.
CAM1
through
CAM4
) to make sure the correct channels are
enabled.
The receiver stays on each camera channel for the selected number of seconds, then switches to
f
the next active channel.
The receiver starts the scan at the currently selected channel, then scans the remaining channels
f
in order.
The receiver will only scan channels that are enabled in the menu.
f
The receiver does not go into quad display during a scan.
f
If you press
f
to manually switch channels, the receiver turns off the scan. Follow the
procedure above to turn it back on.
If...
Try...
The display says
No Signal
when the receiver switches to a
particular channel.
Making sure there is a camera assigned the channel.
-
Making sure the camera is in range of the receiver.
-
Troubleshoot the camera assigned to that channel.
-
The receiver won’t switch to a
particular channel.
Making sure the channel is enabled (set to
-
On
in the
menu).
The receiver won’t scan
channels.
Making sure
-
Scan Time
is not set to
Off
or
Quad
.
Making sure more than one channel is enabled.
-
I can’t switch channels manually.
Making sure more than one channel is enabled.
-
Making sure you are not in quad display.
-
UWS 1101 OM-Hardware 17
28/9/11 10:00:19 AM
