Uniden UH088SX, Owner'S Manual

Page: 31 / 40

(6)
SELECTING A CHANNEL
1. Press key momentarily to activate channel select
mode. The displayed channel will flash.
2. Press or key to select the desired channel.
3. Press key momentarily to exit channel select mode. If no key is
pressed within 5 sec the uh064sx will exit from the channel select mode.
The uh064sx uses the 40 UHF-CB Channels (
).
1. Before you transmit, listen for activity on the selected channel.
2. When the channel is clear, press and hold the PTT key to transmit.
icon appears on the display.
3. When you have finished speaking, release the PTT and listen for a response.
icon then disappears on the display. While receiving, the icon is
displayed.
TO TRANSMIT AND RECEIVE
Channels
22 and 23 are for telemetry and telecommand
applications. Transmit is inhibited on these channels
‘TX’
‘TX’ ‘RX’
ch/txp
ch/txp
Hold the radio with microphone approximately 5 cm in front of your mouth
with the antenna at approximately 45° angle away from your head. Speak in
a clear, normal conversational voice.
For your reference a list of the available channels,
corresponding frequencies and guidelines for
their use is printed on page 12. For Australia,
Channels 05 and 35 are reserved for
Emergency Calls.
TRANSMIT Hi/Mid/Lo POWER SELECT
‘HI’
‘LO’
1. Press and hold key to select desired transmit
level. icon will appear on the display for
maximum transmit level. icon will appear on the
display for minimum transmit level. When there is no 'HI' or 'LO' icon then
the middle transmit level is set. With quality alkaline batteries the transmit
power of the uh064sx is 2.0W (Hi), 0.5W (Mid) and 0.1W (Lo).
ch/txp
txp