Care and Maintenance
General Use
Location
Cleaning
Repairs
Birdies
•
Turn the scanner
before disconnecting the power.
•
Always write down the programmed frequencies in the event of memory loss.
•
If memory is lost, simply reprogram each channel.
The display shows 000.0000 in all channels when there has been a memory loss.
•
Do not use the scanner in high-moisture environments such as the kitchen or bathroom.
•
Avoid placing the unit in direct sunlight or near heating elements or vents.
•
If the scanner receives strong interference or electrical noise, move it or its antenna
away from the source of the noise. If possible, a higher elevation may provide better
reception.
•
Disconnect the power to the unit before cleaning.
•
Clean the outside of the scanner with a mild detergent.
To prevent scratches, do not use abrasive cleaners or solvents. Be careful not to rub the
LCD window.
•
Do not use excessive amounts of water.
•
Do not attempt any repair. The scanner contains no user serviceable parts
•
All radios can receive birdies (undesired signals). If your scanner stops during Scan
mode and no sound is heard, it may be receiving a birdie. Birdies are internally
generated signals inherent in the electronics of the receiver.
Press
to lockout the channel, and then press
to resume scanning.
OFF
L/O
HOLD/RESUME
contact your
retailer or see warranty page for service information.
