Note
: When in Hold mode, you can use the
VFO
to step up or down through the channels.
You can also switch from stepping up/down through channels to stepping up/down
through frequencies by pressing the
VFO
.
RF Attenuation Feature
The UBC785XLT comes with an RF Attenuation feature. If you're near an unusually strong
signal source, the signal may overload the scanner. The scanner may stop repeatedly on
that signal and miss other transmissions.
The RF Attenuation feature works in all modes and attenuates (reduces) the incoming signal
strength to prevent stronger signals from overloading the scanner.
1. Press
MENU
.
2. For Search mode, select
1: SEARCH OPTION
/
2:CHAIN SEARCH
/
4:ATTENUATOR
by rotating the
VFO
and pressing
E
.
For Scan mode, select
2:SCAN OPTION
by rotating the
VFO
and pressing
E
. Then
select the channel number by rotating the
VFO
and pressing
E
.
Select
5:ATTENUATOR
by rotating the
VFO
and pressing
E
.
3. Select
1:ON
by rotating the
VFO
and pressing
E
.
Note
: Attenuation will only be active for the specified channel. In Search mode, it is applied
to the Search ranges in all banks.
☞
Remember! You can also use
▲
or
▼
instead of rotating the
VFO
.
Also instead of pressing
E
, you can press the
VFO
control.
Setting the Delay Mode for Frequency
When scan or search stops on a channel, there is a brief pause before resuming. A default
delay of 2 seconds is automatically set for each frequency . If you want to change the delay
period:
1. Press
MENU
.
2. For Scan mode, select
2:SCAN OPTION
by rotating the
VFO
and pressing
E
.
3. Select the channel number of the stored frequency to be delayed by rotating the
VFO
and pressing
E
.
4. Select
2:DELAY
and press
E
.
5. Rotate the
VFO
to select one of the delay periods and press
E
.
6. For Search mode, select
1:SEARCH OPTION
/
:CHAIN SEARCH
/
3:DELAY
by rotating the
VFO
and pressing
E
, then set to a delay period the same way as the
Scan mode setting.
29
UB343ZH_UBC785XLT_OM_0622 6/22/06 3:01 PM Page 29
