S E T T I N G U P T H E P H O N E [ 1 0 ]
w w w . u n i d e n . c o m
C. Connect the base unit and charge the handset
1) Connect the AC adapter to the
DC IN 9V
jack and to
a standard 120V AC wall outlet.
Note:
• Connect the AC adapter to a continuous power supply
(i.e., an outlet that is not controlled by a switch).
• Place the base unit close to the AC outlet so that you
can unplug the AC adapter easily.
2) Place the handset in the base unit with the keypad
facing forward.
3) Make sure that the
charge
LED illuminates.
If the LED does not illuminate, check to see that the
AC adapter is plugged in and the handset makes
good contact with the base charging contacts.
4) Charge your handset at least
15-20 hours before
plugging into the phone line
.
5) Once the handset battery pack is fully charged,
connect the telephone line cords to the
TEL LINE 1/2
jack and to a telephone outlets.
If your telephone outlet isn't modular,
contact your telephone company for
assistance.
•
Use only the supplied
AD-0006 AC adapter.
Do not use any other
AC adapter.
•Do not place the power
cord where it create a
trip hazard or where it
could become chafed
and create a fire or
electrical hazard.
For 2 line subscriptions,
• If the two phone lines
are in one modular
jack, connect using
TEL LINE 1/2
jack.
• If the two phone lines
are on two separate
modular jacks, connect
using both
TEL LINE
1/2
and
TEL LINE 2
jacks.
note
SE
TTING UP
TH
E PHO
N
E
UP772.book Page 10 Monday, August 29, 2005 1:15 PM
