Setting up the Hardware
Mounting the Charger
1. Use the two holes at the base of the
charger as a template to mark the drill
holes.
2. Using a 3mm (1/8-inch) drill bit, drill
two holes 13mm (1/2 inch) deep.
3. Use the provided screws to attach the
charger to the surface.
You can mount the charger on any flat surface.
2. Line up the battery’s connector with the jack inside the battery
compartment (the connector only fits one way).
3.
Push the connector in firmly. Tug on the battery wires gently to make
sure you have a good connection.
4. Seat the battery case in the battery compartment.
5. Before replacing the battery cover, check the rubber seal located
on the under side of the cover; make sure that the seal is set in the
groove and that there is no foreign matter under the seal.
6. Replace the battery compartment cover. Tighten the screw securely.
WARNING: The accessory battery tray is designed to
prevent the accidental charging of non-rechageable
batteries. Never use non-rechargeable batteries in the
radio without the accessory battery tray.
NOTE
13
UHF CB+VHF Marine Radio
UNIDEN MHS155UV