G E T T I N G S T A R T E D [ 1 6 ]
w w w . u n i d e n . c o m
4) Use the number keys
(0 - 9)
to enter the 3-digit area code. If you
make an error, use the
delete/transfer
key to backspace.
5) Press the
select/channel
key. A confirmation tone sounds.
6) Press the
end
key to complete the setting. The handset returns to standby mode.
Choosing the Dialing Mode
Most phone systems use tone dialing. However some phone systems (such as in rural areas)
still use pulse dialing. Your Uniden phone supports both tone and pulse dialing. The default
setting is tone dialing. If your phone system uses pulse dialing, follow the steps below to
change the dialing mode:
1) When the phone is in standby mode, press and hold the
caller id/
menu
key. The following screen appears.
2) Press the
/vol/
key three times to select
Di al
.
3) Press the
select/channel
key to set the phone to pulse dialing.
4) Press the
end
key and return the handset to main base to
complete the setting. The handset returns to standby mode.
•If you are not sure of
your dialing system,
make a trial call. If the
call connects, leave
the setting as is.
Otherwise, set for
pulse dialing.
•If your phone system
requires pulse dialing
and you need to send
DTMF tones during a
call, you can
temporarily switch
over to tone dialing.
(Refer to “Tone Dialing
Switch-over” on
page 20.)
note
GET
T
I
N
G ST
AR
TE
D
UP038.book 16 ページ ２００４年１月２６日 月曜日 午前１０時１７分
Summary of Contents for DXAI 7288-2 Series
Page 1: ...DXAI 7288 2 ...
Page 64: ...Memo UP038 book 63 ページ ２００４年１月２６日 月曜日 午前１０時１７分 ...