Uniden DSS2415, Manual Quick Start

Page: 49 / 56

[ 43 ]
3) On the receiving handset, to answer the call, press , , or the
ANSWER soft key. If you set the AutoTalk On, pick up the handset from the cradle. If
Anykey Answer is On, press any number key, , or .
4) To finish the intercom call, press or the END soft key on either handset.
Call Transfer Feature
1) During a call, press .
2) Select a handset to transfer the call within 10 seconds.
(Refer to step 2 in the intercom section on page 42).
The call will automatically be placed on hold, and an
intercom tone sounds.
To cancel the transfer, press or on the initiating handset.
3) On the receiving handset, to answer the page, press , , or
the ANSWER soft key. If you set the AutoTalk On, pick up the handset from the cradle.
If Anykey Answer is On, press any number key, , or . The intercom mode
is activated, but the caller is still on hold.
4) To transfer the call, press or the END soft key on the initiating handset, and
press or on the receiving handset.
REPLACING THE BASE
When you replace the base with a different base of the DCT series model (DSS2415,
DSS2455, or DSS2465 series), you need to clear the handset(s) and base ID. To do this,
perform the “System Reset” menu options (“De-register the Handset” and “Deregister the
Base Setting”) (see page 19), then register all the handsets you have (see page 40).
H o l d , t o t r a n s f e r
H a n d s e t # 2
H a n d s e t # 3
BACK BACK OK
UP306BH (DSS2415) ENG OM 8/6/03 9:58 AM Page 43