Switching on and off
To switch the
handset on
and off
To switch the handset off (in case you need to
save battery power):
◗
Press the
HANG UP
button and hold it for
4 seconds
u
The handset plays music. The display shows
Switching Power Off . .
then goes blank.
To switch the handset back on:
◗
Briefly press the
HANG UP
button or replace
the handset on the base unit or charger pod
u
The display may show
No base found
for a
moment before going to idle mode.
Notes
■
When the handset is switched off, it can’t be used for
making calls,
including emergency calls
.
■
When the handset is switched off, it won’t ring for
incoming calls, but the base unit will still ring. To
answer a call when the handset is switched off, you
need to switch it back on. Remember that it may take a
few moments for the handset to re-establish a radio link
with the base unit.
■
If the batteries have become completely run down (or if
the handset is switched off) and you place the handset
in the charging cradle, it may take about 5 minutes to
link with the base unit. If you lift the handset during this
time, it will try to link to the base unit.
!
Make sure mains power to the base unit stays
switched on. The DECT 1915/1915+1 needs electrical
power for normal operation; not just for charging
the batteries.
Ringer
melodies and
volumes
For details of how to change these, refer to the
‘Acoustic’ functions in the Handset and Base menus
(pages 41 and 45).
BASIC USE
10
Summary of Contents for DECT1915+1
Page 63: ...60 ...
