6
Revised 05/08/21
01865 767676
www.unicol.com
STEP 3
Place 2x screws in the bottom two rivnuts of the
span bar plate and slot into chosen keyholes in
mast. From the rear, screw in top two screws into
the span bar and fully tighten all four screws.
STEP 3b
From the rear, screw in four screws into the mount
back plate through the wide span bar slots and
tighten all four screws.
Repeat for the opposite side.
PLEASE NOTE
Once the screens are fitted onto the back plates
(step 6), you may need to adjust the horizontal
positioning. To do this, loosen the screws on the
rear whilst one/two people are holding the screen,
you can then adjust the screens positioning.
Please follow on with Step 5 on Page 4.
TWIN SCREEN
STEP 3a
Feed cables for screen through hole in backplate
and front of mast, down through cable access and
through the span bar. Refit rear top panel using x4
M6 screws. Refit rear door and lock.
