11
Instructions for the installer
3
INSTALLATION
INSTRUCTIONS
3.1 - GENERAL WARNINGS
WARNING!
This boiler is to be destined only to the use
for which it has expressly been designed for.
Every other use is to be considered improper
and therefore dangerous.
This boiler is designed to heat water at a
temperature inferior to boiling point at an
atmospheric pressure.
WARNING!
These appliances are exclusively designed
for indoor installations or installed in adequa-
te sitings. Therefore these appliances must
not be installed and operated outdoors. An
outdoor installation could cause malfunctio-
ning and could be dangerous.
Before installing the boiler the following points
have to be carried out by a professionally
qualified person:
a) The whole system should be thoroughly
flushed in order to remove any residual dirt or
grime which could compromise correct boiler
operation.
b) Check that the chimney/flue pipe has an ade-
quate draught, does not have any constrictions,
and that no other appliance’s flue outlets have
been fitted, unless the chimney is serving more
than one heating appliance, according to the
specific standards and regulations in force. The
connection between the boiler and chimney/flue
outlet can be made only after this verification has
been carried out.
WARNING!
The appliance must be installed by a qualified,
registered engineer, whom, under his own
responsibility, guarantees the compliance
of the standards according to the latest re-
gulations.
NOTE:
The boiler must be connected to a heating system
which is compatible to its performance and output.
