OPERATING AND MAINTENANCE MANUAL CROSS HP
- 15 -
3.5. Adjustment of the Cultivator
3.5.1. Working Depth Adjustment
Fig. 8:
Working depth adjustment
•
Perform hydraulic adjustment by pressurizing the cylinder (A) from the tractor cab, which
extends the cylinder. Then, put on the required number of stops (B) and pressurize the
cylinder (A) again to slide it back to the stops (B). Through this, you can raise or lower the
rear roller of the machine. Secure the cylinder (A) against dropping down with the lever (C).
(Set all 4 cylinders to the same depth.)
•
Then, after the initial setup of the roller cylinders, adjust the drawbar cylinder.
•
When adjusting the working depth with the roller and drawbar cylinders, keep in mind the
parallel position of the machine frame during operation.
•
If required, repeat the steps above several times to obtain the desired working depth.
•
After setting the working depth, you can begin adjustment of the disc harrow and support
wheels.
