UNIA ARES L 2.5, Operating And Maintenance Manual

Page: 20 / 34

OPERATING AND MAINTENANCE MANUAL ARES L
- 23 -
3.5 Adjustment of the Cultivator
3.5.1 Working Depth Adjustment on the roller
Fig. 12. Working depth adjustment on the roller
a- adjustment by means of pins
b - mechanical adjustment; c - hydraulic adjustment
a.
adjustment by means of pins is based on inserting into the appropriate holes [A] so that
we can raise or lower the rear shaft of the machine
b.
Adjustment with the turnbuckle consists of rotating the turnbuckle [B] to left or right side,
through which the machine rear roller is lifted up or lowered
c.
Perform hydraulic adjustment by pressurizing the cylinder [C] from the tractor cab, which
extends the cylinder. Then, put on the required number of stops
[D]
and pressurize the
cylinder
[C]
again to slide it back to the stops
[D]
. Through this, you can raise or lower the
rear roller of the machine. Secure the cylinder [C] against dropping down with the lever
[E] .
3.5.2 Working depth adjustment on the drawbar (chassis option, drive)
Fig. 13.
Depth adjustment on the drawbar (chassis option, drive)