5 / 6
1
Paste the installation sticker on the wall, and keep the horizontal line parallel with the ground
and the red line 1.4m distance to the ground; drill screw holes on suitable position on the wall
according to the installation method (if use 86-box, then no need to drill holes), drill 1~2 outlet
holes according to wiring need.
3
Move the support to align holes on it with holes on the wall, and use the screws to
2
Install the thermometer sensor on the support, connect power cable, network cable
and other wirings, then thread the tails out through the outlet hole.
4
Install the trapezoid screws on the host, put tails inside the wiring socket, then align the
installed trapezoid screws with the holes on support, hang the host on support, meanwhile,
use the hexagonal wrench to tighten the screws via the shown direction. Installation completes.
Steps
1.4M
Outlet hole
STICKER
1.4m calibration line
WALL-MOUNTING
STICKER
1.4m calibration line
WALL-MOUNTING
Attention: If the wall has hard foundation, self-tapping screws shall be used together with
expansion pipe; if the wall has soft foundation, use self-tapping screws directly.
Insert wirings
