19
/
78
• Ensure all the instruments are properly grounded to prevent the accumulation of static.
Preparation Work
1. Connecting the power cable and insert the power plug into protective grounding outlet; use the tilt
adjustment bracket as needed for your viewing angle.
Figure 2-1
Tilt adjustment
2. Press the switch on the rear panel
, the spectrum analyzer will enter standby mode.
3. Press the switch on the front panel
, indicator lights up green, and then the spectrum analyzer is
powered on.
It takes about 30 seconds to initialize the boot, and then the spectrum analyzer enters the system
default menu mode. In order to make this spectrum analyzer perform better, it is recommended that
warm up the spectrum analyzer for 45 minutes after power on.
Usage Tip
Use External Reference Signal
If user want to use an external signal source 10 MHz as reference, please connect signal source to the
10MHz In port on the rear panel. The measuring bar on the top of the screen will indicate
Freq Ref: Ext.
Activate the Option
If user want to activate the option, user need to input secret key of the option. Please contact UNI-T
office to purchase it.
Refer to the following steps to activate the option you have purchased.
1. Save the secret key into USB and then insert it to spectrum analyzer;
2. Press
[System] key > System Information > add token
；
3. Select purchased secret key and then press
[ENTER]
to confirm.
Touch Operation
Spectrum analyzer has 10.1 inch multipoint touch screen for various gesture operating, which includes,
Tap the top right on the screen to enter the main menu
Slide up/down, left/right in waveform area to change the center frequency of X axis or reference
